Group: Member
Post: 1 (0 liked)
Join date: January 2019
Status:
|
|
on Jan 4, 2019 6:51:25 GMT
Posted: Jan 4, 2019 6:51:25 GMT
Hi all. On the Electro 35 GX I just bought on eBay (as-is), old-battery corrosion has eaten through the negative terminal, leaving that wire and a bit of the terminal hanging loose inside the camera. As a test, I ran the wire into the battery compartment and put in a couple of hearing aid batteries with adapters. The lights work and the shutter speed adapts to lighting, so I think the camera will work once I get that wire soldered back on. However, it's pretty cramped where the soldering needs to happen (maybe a 3/8" gap), so I'm trying to figure out how to remove, or at least pivot the battery compartment. I removed the obvious screw at one end of it, but the compartment wasn't loose at all with that screw removed. Does anyone know what I should try next? Here's a link to a picture showing the battery compartment and screw location that I've found so far: www.icloud.com/sharedalbum/#B0W5nhQST49ww0I put a yellow circle around where I removed the screw that I thought was holding in the battery compartment, and a red arrow to the loose wire. Thanks in advance for any tips. Andy
|
|
Group: Administrator
Post: 389 (85 liked)
Join date: January 2014
Status:
|
|
on Jan 8, 2019 21:30:16 GMT
Posted: Jan 8, 2019 21:30:16 GMT
If and when you get it figured out, I would suggest that you bypass one compartment so you can fit two button cells into a single compartment.
|
|
Group: Administrator
Post: 1,370 (301 liked)
Join date: February 2017
Status: Failed treatment for L.B.A. and G.A.S,
|
|
on Jan 11, 2019 2:57:05 GMT
Posted: Jan 11, 2019 2:57:05 GMT
Is there a chance that the tripod socket is acting as the opposite 'screw' to hold the battery box in place? The body is tilted in the image and it's difficult to see if there's some other fastener in place that's obscured by the clear plastic lift-strip in the compartment.
If there's no apparent fastening piece on the right-hand side of the box (per the image's orientation), it might mean that the only thing holding it in place is the screw you removed and the box itself might be pressure-fit to the opening it slides/fits in.
Another possibility might be that the corrosion has created it's own 'glue' as a result of the acid's reaction with the base-metal, and you might be able to wiggle it free - or - apply a cotton swap dipped in cider vinegar to the box edges and let it wick into the outer crevices to break any chemical bond. I wouldn't suggest trying to drip a single drop of vinegar inside though... it can create a whole new issue that's worse than the one you're trying to fix if it winds its way further down.
|
|